HP Photosmart C4200 All-in-One seriesBasics Guide
To replace the print cartridges1. Make sure the HP All-in-One is on.CAUTION: If the HP All-in-One is off when you open the print cartridge door toacce
1 Copper-colored contacts2 Plastic tape with pink pull tab (must be removed before installing)3 Ink nozzles under tapeCAUTION: Do not touch the copper
If you installed a new print cartridge, the HP All-in-One prints a print cartridgealignment page.10. When prompted, ensure plain white paper is loaded
4. If further cleaning is needed, repeat the previous steps using isopropyl (rubbing)alcohol, and wipe the backing thoroughly with a damp cloth to rem
2 Troubleshooting and supportThis chapter contains troubleshooting information for the HP All-in-One. Specific information isprovided for installation
The HP All-in-One will not turn onCause: The HP All-in-One is not properly connected to a power supply.Solution• Make sure the power cord is firmly co
computer and the other into the back of the HP All-in-One. You can connect to any USB port onthe back of your computer.For more information on install
• Check other printers or scanners. You might need to disconnect older products from yourcomputer.• Try connecting the USB cable to another USB port o
3. Close the print cartridge door.4. Press Start Copy Black to continue the current job.Print cartridge troubleshootingIf you are experiencing problem
3 Technical informationThe technical specifications and international regulatory information for the HP All-in-One areprovided in this section.System
Hewlett-Packard Company noticesThe information contained in this document is subject to change without notice.All rights reserved. Reproduction, adapt
Regulatory model identification numberFor regulatory identification purposes, your product is assigned a Regulatory Model Number. TheRegulatory Model
WarrantyWarranty 19Technical information
Chapter 320 Technical informationTechnical information
Contents1 HP All-in-One overviewThe HP All-in-One at a glance...
1 HP All-in-One overviewUse the HP All-in-One to quickly and easily accomplish tasks such as making a copy,scanning documents, or printing photos from
Label Description11 Rear USB port12Power connection** Use only with the power adapter supplied by HP.Control panel buttonsLabel Icon Name and Descript
Label Icon Name and Description5 Cancel button: Stops a task (such as scanning or copying) orresets settings (such as Quality and Copies).6 Scan butto
3. Close the lid.To load 10 x 15 cm (4 x 6 inch) photo paper in the input tray1. Remove all paper from the input tray.2. Insert the stack of photo pap
• Adjust the paper-width guide in the input tray to fit snugly against all paper. Make surethe paper-width guide does not bend the paper in the input
To print one or more 10 x 15 cm (4 x 6 inch) photos1. Insert your memory card into the appropriate slot on the HP All-in-One.The most recent image on
Comentários a estes Manuais