HP Integrity NonStop H-Series Guia do Utilizador descarregar pdf (Página 135)

HP NonStop Shadowbase Command Definitions

Consumer Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

126

CPU cpu_number

Initial Changed

Version Version Values Default Value Specifications Alter

1.000 None Valid CPU number Yes

Client Server Extended Open Target

Specifies the processor where the Consumer runs. This is a required

parameter.

Note: That the CPU can be altered at any time. If altered, the new value

will be used in the event a restart is performed.

DEBUG { OFF }

{ ONSTART }

{ ONERROR }

Initial Changed

Version Version Values Default Value Specifications Alter

2.000 OFF ONSTART ONERROR No

Client Server Extended Open Target

Specifies whether a Consumer enters debug mode and under what

condition. Generally, this should only be set when HP Shadowbase

instructs you to do so for diagnosing problems. However, when you are

debugging user exit code you will need to set this parameter to ONSTART

to enable you to enter the user exit code in Inspect.

OFF the Consumer does not enter debug mode.

ONSTART the Consumer enters debug mode on start-up.

ONERROR the Consumer enters debug mode on an abnormal

event.

If omitted, the default is OFF.

DOCPREPTIMEOUT seconds

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.100 1800 300 32767 Yes

Client Server Extended Open Target

Is the maximum amount of time allowed for an HP Shadowbase Other

Servers to prepare a DOC during start up and during a roll. The default is

1800 seconds (30 minutes). The minimum value is 300 seconds (5

minutes) and the maximum is 32767 (about 9.1 hours). If the DOC

preparation is not completed within the specified time, “STP SERVER

MAY NOT HAVE COMPLETED CLIENT REQUEST” message will appear

in the EMS logs and the Consumer will abend.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 345 346

Sem comentários

HP Integrity NonStop H-Series Guia do Utilizador Página 135