HP RP7 Retail System Model 7100 Manual do Utilizador descarregar pdf (Página 195)

USB Keyboard Interface

Programming Reference Guide

187

USB Keyboard Interface

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable

range for this feature is from 0 to 99 seconds.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20

= 20, etc

3. Go to page 26 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT INTERCODE DELAY SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that repre-

sent the duration which was determined in the

steps above. You will hear a two-beep

indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 32 for some examples of how to set this feature.

Table 32. Intercode Delay Examples

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

STEP ACTION EXAMPLES

1 Desired Setting

No Delay 5 Seconds 60 Seconds 99 Seconds

2 Pad with leading zero(es)

00 05 60 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCODE DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ AND ‘9’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 243 244

Sem comentários

HP RP7 Retail System Model 7100 Manual do Utilizador Página 195