HP Value 2D Wireless Scanner Manual do Utilizador descarregar pdf (Página 25)

Linking the scanner

Link RF devices to base

For RF devices, before configuring the interface it is necessary to link the handheld with the base.

To link the handheld and the base, press the trigger to wake up the handheld and mount it into the base. If

the scanner was previously linked to another base, you must first press and hold the button on the base (>5

seconds), then scan the Unlink bar code before re-linking to the new base.

Figure 4-16 Unlink

Linking to a Bluetooth adapter in serial port profile mode

1. Install any drivers provided with the Bluetooth adapter.

2. Scan the Enable RF Link to Server label below to make the scanner visible to the host computer.

3. Use the host computer’s Bluetooth manager to “Discover new devices” and select "HP Wireless

Bluetooth Scanner." If you receive an error message, it may be necessary to disable security on the

device.

4. Use an RS-232 terminal program to see incoming data on the port designated by the computer's

Bluetooth manager.

Figure 4-17 Enable RF Link to Server

Linking to a Bluetooth adapter in HID mode

1. Install any drivers provided with the Bluetooth adapter.

2. Scan the Link to PC in HID label below.

3. Use the host computer’s Bluetooth manager to “Discover new devices” and select "HP Wireless

Bluetooth Scanner." If you receive an error message, it may be necessary to disable security on the

device.

4. Use a text editor to see incoming data on the port designated by the computer's Bluetooth manager.

Figure 4-18 Link to PC in HID

Linking the scanner 19

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Sem comentários

HP Value 2D Wireless Scanner Manual do Utilizador Página 25