Hp Integrity NonStop J-Series Manual do Utilizador descarregar pdf (Página 226)

INTEGRATING APPLICATIONS

Integrating an Application Into an Existing PATHWAY System

-----------------------------------------------------------------

| |

| PATHCOM $one; START TCP ENABLE-TCP; START TERM term01 |

| |

-----------------------------------------------------------------

Figure 11-6. Sample Obey File That Starts a Terminal

Figure 11-7 shows a sample obey file that stops the PATHWAY

system which "term01" is using.

-----------------------------------------------------------------

| |

| PATHCOM $one; SHUTDOWN, WAIT |

| |

-----------------------------------------------------------------

Figure 11-7. Sample Obey File That Stops a PATHWAY System

Refer to the PATHWAY System Management Reference Manual for more

information about adding terminals to a PATHWAY system.

INTEGRATING AN APPLICATION INTO AN EXISTING PATHWAY SYSTEM

You can add an ENABLE application to an existing PATHWAY system

by performing the tasks described in the following paragraphs.

Some of these tasks apply to application generation; other tasks

apply to application integration.

Generating the Application

When you generate an application for integration within an

existing PATHWAY system:

1. Direct the object code for the generated application to an

object file used by the existing PATHWAY system. To perform

this task, supply the name of the object file as a value for

the SCOBOLOBJECT attribute. For more information, refer to

the discussion "Directing Object Code to the Same Object

File" earlier in this section.

11-22

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 361 362

Sem comentários

Hp Integrity NonStop J-Series Manual do Utilizador Página 226