Hp Netserver L Server series Manual do Utilizador descarregar pdf (Página 49)

Chapter 6 Troubleshooting

Message

Mouse error

Incorrect System

Configuration

Corrective Action

Keyboard error Check that the keyboard is connected to the correct

connector (not the mouse connector) at the rear of the

system.

Replace the keyboard. If the problem persists, contact

your HP support organization.

Check that the mouse is connected to the correct

connector (not the keyboard connector) at the rear of

the system.

Replace the mouse. If the problem persists, contact your

HP support organization.

Press the F2 key to run the Setup utility. Change settings

as required. Press theFlO function key to exit, and

answer "Yes" to save the changes.

No Error Messages Displayed

If a POST error is detected before video display starts, a beep error message may

be generated. If so, refer to the list of Beep Error Messages in Information

Assistant.

General Checks

1. All external cables and power cables are ^-mly plugged in.

2. The power outlet is working.

3. The computer and display are turned on. (The power-on indicator should

be illuminated.)

4. The display’s contrast and brightness settings are correct.

5. All internal cables are properly connected, and all boards are ^-mly seated.

6. Check that the system board is fully seated in the backplane slot and that

the retaining latches at the top of the system board are ^ly lowered.

7. Check that the CPU module is fully seated in the upper (primary) CPU

socket on the system board.

8. Check that the terminator board or second CPU module is ^ly seated in

the lower (secondary) CPU socket on the system board.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 111 112

Sem comentários

Hp Netserver L Server series Manual do Utilizador Página 49