Hp ProLiant DL380p Gen8 Server Manual do Utilizador descarregar pdf (Página 66)

Hardware options installation 66

Insert the power supply into the power supply bay until it clicks into place.

4. Connect the power cord to the power supply.

5. Route the power cord. Use best practices when routing power cords and other cables. A cable

management arm is available to help with routing. To obtain a cable management arm, contact an HP

authorized reseller.

6. Connect the power cord to the AC power source.

7. Be sure that the power supply LED is green ("Rear panel LEDs and buttons" on page 14).

48V DC power supply option

One of the following optional HP input cables with pre-fastened ring tongues may be purchased from HP or

an authorized reseller:

• A5S97A—1.3-m (4.27-ft) 48V DC Power Cable Kit

• A5S98A—2.5-m (8.20-ft) 48V DC Power Cable Kit

If you are not using an optional HP input cable, use an HP-approved 10 or 12 AWG green and yellow

ground cable, no shorter than 150 cm (59.06 in), and 10 or 12 AWG power cables.

To install the component:

1. Remove the blank.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 133 134

Sem comentários

Hp ProLiant DL380p Gen8 Server Manual do Utilizador Página 66