Hp ProLiant DL385 G2 Server Manual do Utilizador descarregar pdf (Página 53)

Hardware options installation 53

Remove the power supply blank.

WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect

the power cord to the power supply until the power supply is installed.

2. Slide the power supply into the power supply bay until the release/lock lever clicks, securing the

power supply.

3. Connect the power cord to the power supply.

4. Tighten the two retaining screws on either side of the power cord connector.

5. Route the power cord:

o If the cable management arm has a left-hand swing, route the power cord through the cable

management arm.

o If the cable management arm has a right-hand swing, remove the cable management arm or

convert it for left-hand swing. For removal instructions, see "Cable management arm with right-

hand swing (on page 29)." For conversion instructions, see the instructions that ship with the 2U

Quick Deploy Rail System.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 114 115

Sem comentários

Hp ProLiant DL385 G2 Server Manual do Utilizador Página 53