Hp RP3440 Manual do Utilizador descarregar pdf (Página 173)

5. Pull the drive straight out to remove it from the chassis.

Figure 6-60 Removing the Removable Media Drive

Replacing a Removable Media Drive

To replace the removable media drive, follow these steps:

1. If a removable media drive has not previously been installed in the server, the drive slot is

covered with a DVD drive filler. Remove the DVD drive filler.

2. Slide the replacement drive into the drive bay until it stops sliding and the retaining clips

on both sides of the drive snap into place.

3. Connect the IDE cable on the back of the drive.

4. Replace the top cover.

5. Reconnect the power and external cables and turn on the server.

6. Verify the drive replacement and operation by using the system utilities. (For additional

information, see Appendix B (page 199) or the HP Integrity and HP 9000 iLO MP Operations

Guide.)

• Use the iLO MP commands to verify operation.

• Use the BCH commands to verify operation.

• Use diagnostics provided by the ODE to exercise the newly installed module.

Removing and Replacing the iLO MP Card

The iLO MP offers remote server management through an independent iLO MP.

Removing the iLO MP Card

To remove the iLO MP card, follow these steps:

1. Power off the server.

2. Use the MP LS command to display network settings for the iLO MP.

3. Record these network settings. You will need to input the settings when a new iLO MP card

is installed.

Removing and Replacing the iLO MP Card 173

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 209 210

Sem comentários

Hp RP3440 Manual do Utilizador Página 173