Hp BL460C G7 Manual do Utilizador descarregar pdf (Página 34)

Hardware options installation 34

Multi-processor Lockstep population order

For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each

processor in the following order:

• RDIMM

o First: A and B

o Next: D and E

o Do not populate slots C or F.

• UDIMM

o First: A and B

o Last: D and E

o Do not populate slots C or F.

After installing the DIMMs, use RBSU to configure the system for Lockstep memory support.

Installing a DIMM

CAUTION: To avoid damage to the hard drives, memory, and other system components, the air

baffle, drive blanks, and access panel must be installed when the server is powered up.

1. Power down the server ("Power down the server blade" on page 12).

2. Remove the server blade (on page 13).

3. Remove the access panel (on page 14).

4. Remove all DIMM baffles ("Remove the DIMM baffle" on page 14).

5. Open the DIMM slot latches.

6. Install the DIMM.

7. Install all DIMM baffles.

8. Install the access panel (on page 14).

If you are installing DIMMs in a mirrored or lock-step configuration, configure this mode in RBSU ("HP

ROM-Based Setup Utility" on page 55).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 105 106

Sem comentários

Hp BL460C G7 Manual do Utilizador Página 34