Hp LC 2000 Manual do Utilizador Página 169
- Página / 194
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
161
A Specifications
Power Requirements
Table A-1. HP NetServer LC 2000/2000r Input Power
Input Voltage and Frequency 100-240 VAC
±
10%; 50/60 Hz
Maximum inrush current
8 AMPs peak (for 1 power supply) 120 VAC
or 32 AMPs peak (2 power supplies)
16 AMPs peak (for 1 power supply) 240 VAC
or 32 AMPs peak (2 power supplies)
Delayed action circuit breaker
recommended
North America: a 20 A minimum delayed action
circuit recommended for each 16 A power
distribution unit (PDU) that is connected to an HP
NetServer LC 2000/2000r.
Europe (single server in a rack): use a
16 A-minimum circuit with one IEC MCB
C-type breaker for each 16-Amp PDU.
Europe (multiple servers in a rack): use a
16-amp-minimum circuit with one IEC MCB
D-type breaker for each 16 A PDU.
NOTE Some local codes do not allow 16-amp service for a 16-amp
device. Consult a qualified electrician or local regulatory
authority before beginning electrical site preparation.
Table A-2. HP NetServer LC 2000/2000r Power Ratings
AC Input
Voltages
Maximum Input
Power (VA)
Maximum Input
Power (W)
Maximum Operating
Current RMS (AMPS)
100 VAC 545 540 5.5
120 VAC 531 525 4.5
208 VAC 516 506 2.5
230/240 VAC 514 504 2.3
- HP NetServer LC 2000/2000r 1
- Installation Guide 1
- Contents 3
- 1 Setting Up the HP NetServer 9
- Pedestal Installation 10
- Rack Mount Installation 13
- Front of HP NetServer 17
- Front Panel LED Indicators 19
- Power Supply Module Indicator 23
- Keyboard Mouse 24
- Video NIC 24
- (Embedded) 24
- Management 24
- NIC Indicators 25
- Link/Activity 25
- Transfer Rate 25
- Powering Up the HP NetServer 26
- Sleep States (ACPI) 27
- 3 Opening and Closing the HP 29
- NetServer 29
- Foot (4) 31
- Anti-Tip 31
- Foot Extended 31
- Slide Securing Screws (2) 33
- Hinge Pins(3) Handles(2) 33
- Top Cover 35
- Bottom Cover 35
- Cover Pull 35
- Right Cover 38
- Thumbscrews (2) 38
- Removing the Pedestal 40
- Hardware Mirroring 43
- Mass Storage Guidelines 44
- • General Guidelines 44
- • SCSI Device Selection 44
- • SCSI Drive Addressing 45
- • Filler Panels and Spacers 46
- Filler Panels 47
- Pedestal Configurations for 48
- Note: Con = Connector 49
- Connectors A and B 50
- Con = Connector 50
- Cabling Configurations 51
- Drive Spacer 55
- Locking Latch 56
- Removing Hot Swap Hard Drives 58
- Non-Hot Swap 59
- (Optional) 59
- DIMM Installation 64
- DIMM Removal 67
- Boot Priority 70
- IRQ Settings 71
- System Board PCI Slots 71
- Installing Accessory Boards 73
- 1. Open Tab 75
- 2. Lift Latch 75
- 3. Remove Slot Cover 75
- 1. Insert Board 77
- 2. Close Latch 77
- 3. Turn Tab 77
- Figure 7-1. System Board 80
- Installing the Processor 81
- Processor Cage 83
- Terminator 84
- Figure 7-6. Installing VRM 86
- Channel(2) 97
- Rear of HP NetServer 101
- Left Rear 101
- Rack Column 101
- Cable Management Arm 101
- Attaching the Front Bezel 102
- Mouse, and UPS 105
- Introduction 107
- HP NetServer Navigator CD-ROM 107
- Internet FTP 109
- Assistant 111
- • Show System Information: 113
- • Configure Disk Array: 113
- • Install Utility Partition: 113
- • Execute Card Utilities: 113
- NOS Installation 115
- HP Management Solutions 116
- Setup Utility 120
- Using the Setup Screens 121
- • Small arrow points ( 122
- ➢Hardware Security 123
- Floppy check: [Disabled] 126
- Summary screen: [Enabled] 126
- Quick Boot mode: [Enabled] 126
- ➢Boot Device Priority 126
- ➢Hard Drive Priority 126
- Clearing CMOS 128
- SCSI Configuration Utility 129
- 11 Information Assistant 135
- Installing from the CD-ROM 137
- :\infoasst\setup 137
- 12 Troubleshooting 139
- Common Installation Problems 140
- Chapter 12 Troubleshooting 141
- Error Message Is Displayed 142
- No Error Messages Displayed 143
- Open = Off 145
- Closed = On 145
- Hardware Problems 147
- Keyboard or Mouse Do Not Work 148
- CD-ROM Drive Does Not Work 148
- Password Problems 149
- Battery Problems 150
- 13 Alternative Rack Mounting 153
- Tools Required 154
- • Nut driver or wrench 154
- • T-15 and T-25 Torx Drivers 154
- • Marking pen 154
- Preparing the Rack 156
- Mounting 161
- Channels(2) 162
- A Specifications 169
- Appendix A Specifications 170
- Environmental Requirements 171
- Physical Requirements 172
- Video Support 173
- B Regulatory Information 175
- Notice for Japan 177
- Notice for Korea 178
- Notice for Taiwan 179
- Notice for European Union 179
- Battery Statements 183
- C Service and Support 185
- Warranty 187
Manuais e produtos relacionados com Computadores Hp LC 2000
Computadores Hp XW6400X Manual do Utilizador
(90 páginas)
(90 páginas)
Computadores Hp 576X-B Manual do Utilizador
(1 páginas)
(1 páginas)
Computadores Hp BL2X220C Manual do Utilizador
(82 páginas)
(82 páginas)
Computadores Hp Vectra VL 5/xxx Manual do Utilizador
(102 páginas)
(102 páginas)
Computadores Hp BA322 90087 Manual do Utilizador
(346 páginas)
(346 páginas)
Computadores Hp XW6200 Manual do Utilizador
(78 páginas)
(78 páginas)
Computadores Hp ProLiant DL785 Manual do Utilizador
(42 páginas)
(42 páginas)
Computadores Hp LH 3r Manual do Utilizador
(23 páginas)
(23 páginas)
Computadores Hp S6150AP Manual do Utilizador
(1 páginas)
(1 páginas)
Computadores Hp T550 Manual do Utilizador
(2 páginas)
(2 páginas)
Computadores Hp Vectra 500 Series Manual do Utilizador
(146 páginas)
(146 páginas)
Computadores Hp XW4300 Manual do Utilizador
(85 páginas)
(85 páginas)
Computadores Hp AD117-9003A-ED3 Manual do Utilizador
(177 páginas)
(177 páginas)
Computadores Hp TC2120 Manual do Utilizador
(125 páginas)
(125 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.054 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais