HP Tool Storage 354903-001 Manual do Utilizador descarregar pdf (Página 12)

12 HP MSA 500 G2 Storage System Maintenance and Service Guide

− In RAID 1+0 configurations, any drives that are not mirrored to other

removed or failed drives can be simultaneously replaced offline without

data loss.

To remove the component:

CAUTION: To prevent improper cooling and thermal damage,

do not operate the storage system unless all bays are populated with

either a component or a blank.

1. Determine the status of the hard drive from the hot-plug hard drive LEDs

("Hot-Plug SCSI Hard Drive LEDs" on page 41

2. Back up all data on the hard drive.

3. Remove the hard drive.

To replace the hot-plug SCSI hard drive:

1. Slide the drive into the cage until it clicks, locking the drive into place.

2. Close the lever.

3. Be sure that the drive LEDs illuminate one at a time and then turn off

together to indicate that the system has recognized the new drive.

In fault-tolerant configurations, allow the replacement drive to be

reconstructed automatically with data from the other drives. While

reconstruction is in progress, the online LED flashes.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Sem comentários

HP Tool Storage 354903-001 Manual do Utilizador Página 12