Hp C737990900 Manual do Utilizador Página 133
- Página / 174
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Commands 133
Commands
■ Power On, SCSI Reset, Bus Device Reset
■ Media inserted
■ A load command executed by a third party
■ Mode Sense parameters changed by another initiator
■ Drive firmware has been updated
U
NIT ATTENTION sense will persist for a host until the host sends a command
that has Unit Attention as part of its pre-execution checks. When the Unit
Attention pre-execution check fails, the
UNIT ATTENTION sense is copied to the
Current sense and
CHECK CONDITION status is reported to the host. The UNIT
ATTENTION
sense is cleared. The host is then expected to issue a REQUEST
SENSE
command to recover the UNIT ATTENTION sense (which is now the new
Current sense).
It is possible for multiple
UNIT ATTENTION conditions to arise (for example,
after a power-on followed by a tape load), such that the initiator does not read
one condition before the next occurs. In this case a prioritizing scheme is used.
If a
UNIT ATTENTION condition exists and a new one occurs, then the UNIT
ATTENTION
sense will be overwritten by the new sense only if the new sense
has a higher priority.
The order of priority is as follows:
U
NIT ATTENTION sense that arises as a result of a command executing will not
be posted to the sending initiator, but will be set for the other initiators.
DEFERRED ERROR Sense
DEFERRED ERROR sense is generated when an operation fails and CHECK
CONDITION
status cannot be reported to the host for one of the following
reasons:
■ The operation had immediate-report on (for example, REWIND with the
Immed bit set, or
LOAD).
■ The operation was a write that was immediate-reported on after its data
was successfully placed in the write-behind queue.
Power-on, Reset
Tape Loaded
Mode Parameters Changed
Microcode Downloaded
highest priority
lowest priority
- Edition 4, February 2003 1
- Revision History 2
- The Purpose of this Manual 3
- Related Documents 3
- Documentation Map 4
- Cartridges 5
- Interface 5
- Dealing with Errors 6
- Ultrium Features 6
- 1 Interface Implementation 13 9
- 2 Messages 25 10
- 3 Commands—Introduction 31 10
- 4 Commands 41 10
- Contents 11 11
- Glossary 165 12
- Index 169 12
- Interface Implementation 13
- Supported Messages 14
- Supported Commands 14
- SCSI Features 15
- Abort Handling 16
- Multi-Initiator Support 19
- Fibre Channel Operation 20
- Addresses 21
- Implications for Libraries 22
- Field Replaceable Units 23
- Messages 25
- 26 Messages 26
- Name Code Support 26
- Extended Message Support 27
- 30 Messages 30
- Commands—Introduction 31
- Command Details 32
- Pre-Execution Checks 32
- Deferred Error Check 33
- Diagnostic Status Check 33
- Fixed Bit Check 34
- Flag Link Check 34
- Illegal Command Check 34
- Illegal Field/Request Check 34
- Media Access Check 35
- Media Information Check 36
- Media Write Check 37
- Parameter List Check 37
- Reservation Check 37
- Command Descriptor Block 38
- CHECK CONDITION 39
- 40 Commands—Introduction 40
- ERASE 19h 42
- Erase Specific Status: 43
- INQUIRY 12h 44
- INQUIRY Data Pages 45
- Inquiry Data 46
- Inquiry Data Fields 47
- Vital Product Data Pages 49
- Unit Serial Number Page 50
- Device Identification Page 51
- Defined Identifiers 51
- Port Name (FC only) 52
- Device Name (FC only) 52
- Port Identifier (FC only) 53
- LOAD/UNLOAD 1Bh 55
- Load/Unload Specific Status: 56
- Loading a Cartridge 56
- Unloading a Cartridge 57
- LOCATE 2Bh 58
- Locate Specific Status: 59
- LOG SELECT 4Ch 60
- LOG SENSE 4Dh 62
- Log Page Format 63
- Supported Log Pages Page 64
- Write Error Counters Log Page 65
- Read Error Counters Log Page 66
- TapeAlert Log Page 67
- Tape Usage Log Page 69
- Tape Capacity Log Page 69
- Data Compression Log Page 70
- Performance Data Log Page 70
- MODE SELECT 15h/55h 72
- Mode Parameter Pages 74
- Mode Parameter Header 75
- 10-byte Header 76
- Header Fields 76
- Mode Block Descriptor 77
- Disconnect-Reconnect Page 79
- FC Drives 80
- Control Mode Page 81
- Control Mode Page Fields: 82
- Device Configuration Page 83
- Changeable Parameters: 84
- Unchangeable Parameters: 84
- Medium Partitions Mode Page 85
- (Partition Units) 86
- CHECK CONDITION with a sense 89
- -1 through -64 90
- MODE SENSE 1Ah/5Ah 91
- READ 08h 95
- GOOD status is returned 96
- Read Specific Status: 97
- READ ATTRIBUTE 8Ch 99
- CDB Fields: 100
- Commands 101
- MAM Attribute Data 103
- Attribute ID Values 104
- Medium Common Attributes 106
- Host Common Attributes 107
- Commands 109 109
- READ BLOCK LIMITS 05h 110
- READ BUFFER 3Ch 111
- Memory Sizes: 112
- Returned Data: 113
- READ POSITION 34h 115
- Returned Data Fields: 117
- Pre-Execution Checks: 119
- Command Descriptor Block: 119
- Specific Status: 119
- Data Returned 120
- RELEASE UNIT 17h/57h 121
- 10-Byte Only 122
- Release Unit Specific Status: 122
- REPORT DENSITY SUPPORT 44h 123
- Descriptor Blocks 124
- MODE SENSE command 125
- REPORT LUNS A0h 126
- REQUEST SENSE 03h 128
- Request Sense Data 129
- Returned Sense Data Fields: 130
- Sense Data Management 131
- Current Sense 132
- UNIT ATTENTION Sense 132
- DEFERRED ERROR Sense 133
- Write-Behind Deferred Errors: 134
- Bus Release Deferred Errors: 134
- Sense Keys 135
- Additional Sense Codes 136
- WRITE BUFFER command 139
- Error Codes 140
- RESERVE UNIT 16h/56h 141
- RELEASE UNIT command with 143
- REWIND 01h 144
- SEND DIAGNOSTIC 1Dh 145
- Data Required 146
- Specific Status 146
- Standard Self-Test 147
- SPACE 11h 148
- Space Specific Status: 149
- TEST UNIT READY 00h 151
- VERIFY 13h 152
- WRITE 0Ah 154
- Write Specific Status: 155
- Residue Information: 155
- WRITE ATTRIBUTE 8Dh 157
- Parameter List Format: 159
- WRITE BUFFER 3Bh 160
- Memory Sizes 162
- Commands 163 163
- WRITE FILEMARKS 10h 164
- Glossary 165
- 166 glossary 166
- 168 glossary 168
Manuais e produtos relacionados com Hardware Hp C737990900
Hardware Hp XU800 Manual do Utilizador
(140 páginas)
(140 páginas)
Hardware Hp HD1600 Manual do Utilizador
(2 páginas)
(2 páginas)
Hardware Hp MSL6000 Series Manual do Utilizador
(182 páginas)
(182 páginas)
Hardware Hp Wireless Device Manual do Utilizador
(31 páginas)
(31 páginas)
Hardware Hp LTO 4 SAS Manual do Utilizador
(46 páginas)
(46 páginas)
Hardware Hp ProLiant DL385 Manual do Utilizador
(47 páginas)
(47 páginas)
Hardware Hp D2D120 Manual do Utilizador
(20 páginas)
(20 páginas)
Hardware Hp 4250 Manual do Utilizador
(4 páginas)
(4 páginas)
Hardware Hp MSL2024 Manual do Utilizador
(4 páginas)
(4 páginas)
Hardware Hp 100TX NightDIRECTOR/100 Manual do Utilizador
(121 páginas)
(121 páginas)
Hardware Hp 958-000290-000 Manual do Utilizador
(144 páginas)
(144 páginas)
Hardware Hp mv2040 Manual do Utilizador
(2 páginas)
(2 páginas)
Hardware Hp Fax 650 Manual do Utilizador
(20 páginas)
(20 páginas)
Hardware Hp NAS 2000s Manual do Utilizador
(20 páginas)
(20 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.088 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais