
3. Lift the front edge of the Bluetooth module compartment cover (2), swing it up and forward, and
remove the cover.
4. Remove the following screw covers and screws:
(1) Four rubber screw covers. The rubber screw covers are included in the Rubber Kit, spare part
number 481106-001.
(2) Six Torx T8M2.5×6.0 screws.
(3) One Phillips PM2.0×6.0 screw.
(4) One Torx T8M2.0×5.0 screw.
5. Turn the computer right-side up, with the front toward you.
6. Release the ZIF connector to which the TouchPad cable is attached and disconnect the TouchPad
cable (1) from the system board.
Component replacement procedures 53
Comentários a estes Manuais