With card present, before being suspended: 40.6 mA
Without card present: 380 μA
After being suspended with smart card present: 380
μA
Support T0, T1 protocol
Support I2C memory card, SLE4418, SLE4428, SLE4432, SLE4442,
SLE4436,
SLE5536, SLE6636, AT88SC1608, AT45D041 card and AT45DB041
card via external EEPROM
Support ISO7816 Class A, B and C (5V/3V/1.8V) card
Implemented as an USB full speed device with bulk transfer
endpoint, Mass
Storage endpoint
Built-in PLL for USB and Smart Card clocks requirement
Support EEPROM for USB descriptors customization (PID/VID/
iManufacturer/iProduct/Serial Number), Direct Web Page Link, and
accessing memory card module.
EEPROM programmable via USB interface
Support software update for memory card module
Support Direct Web Page Link via configuration in external EEPROM
Support short APDU and extended APDU
Compatible with Microsoft USB-CCID driver
Support remote wake up through inserting card/removing card
Support USB selective suspend
Support Power Saving Mode (Using one pin to select between
Normal/PWR Saving Mode)
Support card power over current protection mechanism
Built in resonator.
Support USB LPM (Link Power Management) features.
Embedded clock source.
10 Mbit/s operation (10BASE-T; IEEE 802.3i; IEEE 802.3 clauses 13-14)
100 Mbit/s operation (100BASE-TX; IEEE 802.3u; IEEE 802.3 clauses 21-30)
1000 Mbit/s operation (1000BASE-T; IEEE 802.3ab; IEEE 8023 clauses 40)
Auto-Negotiation (Automatic Speed Selection)
Full Duplex Operation at all Speeds, Half Duplex operation at 10 and 100
Mbit/s
IEEE 802.1p QoS (Quality of Service) Support
IEEE 802.1q VLAN support
IEEE 802.3x Flow Control (IEEE 802.3 clauses 31-32; configurable)
IEEE 802.3az EEE (Energy Efficient Ethernet)
Jumbo Frame 9K
Auto MDI/MDIX Crossover cable detection
Comentários a estes Manuais