HP G6 Manual do Utilizador descarregar pdf (Página 84)

●

PCH heat sink (see

PCH heat sink on page 82)

●

Processor (see

Processor on page 83)

Remove the system board:

1. Disconnect the following cables from the system board:

(1) Display panel cable

(2) Optical drive cable

(3) USB board cable

(4) Power connector cable

Remove the PM 2.5 × 4.5 screw (1) that secures the system board to the base enclosure.

3. Lift the right side of the system board (2) until it rests at an angle.

4. Remove the system board (3) by sliding it up and to the right at an angle.

Reverse this procedure to install the system board.

76 Chapter 4 Removal and replacement procedures ENWW

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 123 124

Sem comentários

HP G6 Manual do Utilizador Página 84