HP Server tc2100 Guia de Instalação descarregar pdf (Página 18)

Chapter 2 Installing Microsoft Windows NT 4.0 Server

3. Connect clients PC to the network your HP server operates on.

4. Open a command prompt window on your HP server (Start | Program |

Command Prompt) and verify the TCP/IP configuration you have set

during Windows NT installation by entering:

ipconfig /all

5. To verify the server and clients can communicate properly:

a. From one of the clients, open a command prompt and type:

ping computername

Where computername is the server name you entered during Windows

NT installation. You should get four reply's from your new server. If there

is a link problem it must be fixed before going any further.

You may test the link further by doing a ping between two clients at the

same command prompt, type:

ping other_client_IPaddress

You should get four reply's from the second client.

b. Copy files back and forth from the clients to the server.

Section 7. Installing Additional Adapters Drivers

Ethernet Adapter

We will use here as an example the installation of an additional HP 10/100TX PCI

LAN Adapter (HP product number D5013B) - this HP accessory is supported on your

HP Server tc2100.

1. Open Start | Settings | Control Panel | Network | Adapters.

2. Select Add.

3. As HP provides a specific driver, click Have Disk when given a list of

Network Adapter drivers.

4. Insert the HP LAN driver diskette provided with the accessory card then

press Enter. Note that you may have to browse the diskette to locate the

driver.

5. Select the "HP 10/100TX PCI LAN Adapter" then click OK.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Sem comentários

HP Server tc2100 Guia de Instalação Página 18