HP 5300 Guia de Instalação descarregar pdf (Página 17)

HP ProCurve Switch xl Modules

Installing the Modules

Connecting an HP ProCurve External Power Supply

Power over Ethernet technology allows IP telephones, wireless LAN Access

Points and other appliances to receive power as well as data over existing LAN

cabling, without needing to modify the existing Ethernet infrastructure. For

more information on PoE, refer to the HP ProCurve PoE Planning and

Implementation Guide.

The HP ProCurve Switch PoE xl Module (J8161A) is a module for the HP

ProCurve 5300xl Switch and has 24 auto-sensing 10/100-TX RJ-45 ports. All 24

ports are capable of supplying PoE power. However, for the module itself to

be able to supply PoE power it first must be connected to an external power

supply (EPS) port on an HP ProCurve 600 Redundant and External Power

Supply (J8168A) or an HP ProCurve 610 External Power Supply (J8169A),

hereafter referred to as the External Power Supply (EPS).

Connecting the EPS connector

1. If installed, remove the RJ-45 connectors from ports 6 and 13.

2. Connect the EPS cable. Push the connector in firmly until fully seated.

3. Install the cable retention bracket (CRB).

4. Secure the CRB to the module bulkhead.

EPS Receptacle

After connecting the EPS

cable to the module,

install the CRB on the

Cable

Retention

Bracket

EPS Cable

Connector

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Sem comentários

HP 5300 Guia de Instalação Página 17