HP 720 Series Guia de Instalação descarregar pdf (Página 13)

3. Secure the power cord to the controller with the provided cable tie.

Figure 9 Securing the power cord to the controller

3. Cable tie anchor2. Cable tie1. Power cable

Connect the network cables

Connect the network cables from the network devices or patch panels to the controller.

Using the RJ-45 connectors

To connect:

Push the RJ-45 plug into the RJ-45 port until the tab on the plug clicks into place. The Link LED lights

when the devices at either end of the cables are powered on.

To disconnect:

Press the small tab on the plug and pull the plug out of the port.

Installing or removing optional mini-GBICs

You can install or remove an optional mini-GBIC from a mini-GBIC slot without having to power

off the controller. Use only HP mini-GBICs.

Mini-GBIC information

Dual-personality ports use either the 10/100/1000Base-T RJ-45 connector, or a supported HP

mini-GBIC (Small Form Factor Pluggable (SFP)) for fiber-optic connection. By default, the RJ-45

connectors are enabled.

The optional mini-GBICs add support for these speeds and technologies:

Table 4 Optional network speeds and technologies

Cabling*TechnologySpeed

Fiber (multimode)100-FX100 Mbps

Fiber (single mode)100-BX

Fiber (multimode)1000-SX1 Gbps

Fiber (multimode or single mode)1000-LX

Fiber (single mode)1000-LH

Fiber (single mode)1000-BX

*See also “Cabling and safety standards” (page 25).

Installation procedures 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Sem comentários

HP 720 Series Guia de Instalação Página 13