HP 744 Manual de Serviço descarregar pdf (Página 78)

4-6

Cables

Connecting a Single Monitor, Multi-Display System, or Text-Only Termi-

nal

Figure 4-2 Connecting a Monitor

1 Plug the small connector of the conversion video cable into the video con-

nector of your board computer.

2 Connect the monitor cable to the conversion cable.

3 Connect the monitor cable to your monitor as follows:

• Red to R (RED)

• Green to G (GREEN)

• Blue to B (BLUE)

Power Cord

If your monitor has an attached power cord, connect the plug to a power

source. If your monitor has a separate cord, connect the cord to the monitor,

then connect the plug to a power source.

WARNING: Do not connect your monitor to a power extension strip. Doing so can

cause a shock hazard.

NOTE: Do not turn on your monitor at this time.

Connecting a Terminal

This section provides step-by-step instructions for connecting a terminal to

your Model 744 Board Computer. Refer to Figure 4-3.

Using the HP A4301A conversion RS-232C Cable, plug its micro-miniature con-

nector to one of the RS-232 connectors as follows:

• The recommended port for connecting a terminal is the (A) port.

• Using the (B) port for terminal connection is not recommended.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 143 144

Sem comentários

HP 744 Manual de Serviço Página 78