HP 8100 - Elite Convertible Minitower PC Guia do Utilizador descarregar pdf (Página 31)

6. Install four 6-32 isolation mounting guide screws, two on each side of the drive.

Figure 23 Installing the Hard Drive Guide Screws

NOTE: The hard drive uses 6-32 isolation mounting guide screws. Eight extra guide screws are

installed on the hard drive bracket under the access panel. The HP-supplied isolation mounting

guide screws are silver and blue. Refer to

Installing Additional Drives on page 21 for an illustration

of the extra 6-32 isolation mounting guide screws location.

If you are replacing a drive, transfer the guide screws from the old drive to the new drive.

7. Slide the hard drive down into the drive cage until it locks. The drivelock automatically secures the

drive in the bay.

Figure 24 Installing a Hard Drive into the Hard Drive Bay

CAUTION: Make sure the guide screws line up with the guide slots in the drive cage. The use of

unnecessary force when installing any drive into the drive bay may result in damage to the drive.

ENWW Installing Additional Drives 25

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Sem comentários

HP 8100 - Elite Convertible Minitower PC Guia do Utilizador Página 31