HP Blade Workstation Client Guia de Início Rápido descarregar pdf (Página 35)

Getting Started

Getting Started www.hp.com 31

Red Power LED

flashes nine

times, once every

second, followed

by a two-second

pause. The beeps

continue for five

iterations, then

stop. The LED

flashes continue

until the problem

is resolved.

9 System powers on

but is unable to

boot.

1. Check that the

voltage selector,

located on the rear of

the power supply

(some models), is set

to the appropriate

voltage. Proper

voltage setting

depends on your

region.

2. Replace the system

board.

3. Replace the

processor.

Red Power LED

flashes ten times,

once every

second, followed

by a two-second

pause. The beeps

continue for five

iterations, then

stop. The LED

flashes continue

until the problem

is resolved.

10 Bad option card. 1. Check each option

card by removing the

card (one at a time if

multiple cards), then

power on the system

to see if fault goes

away.

2. Once a bad card is

identified, remove

and replace the bad

option card.

3. Replace the system

board.

Diagnostic Front Panel LEDs and Audible Codes

Activity Beeps

Possible

Cause

Recommended

Action

1 2 ... 30 31 32 33 34 35 36 37 38

Comentários a estes Manuais

Sem comentários