HP HP ProCurve Series 6600 Manual do Utilizador descarregar pdf (Página 10)

1.9

Switch Management Access Addresses

If these ranges are not set, the active device can be managed from any address. This applies to access via

web, telnet, ssh, and SNMP.

hp-test(config)# ip authorized-managers 10.229.3.0 255.255.255.0

hp-test(config)# ip authorized-managers 10.229.240.0 255.255.240.0

Recommendation:

When configuring the switch do not forget to limit the management access to the selected network ranges.

Caution:

If you use an IPv6 address to manage the switch, you must not forget to set IPv6 management access

restrictions for the switch.

hp-test(config)# ipv6 authorized-managers 2001:718:802:3::93e5:30f

ffff:ffff:ffff:ffff::0

1.10

Remote Logging

Event logging via the syslog protocol. This command sets the remote server address.

hp-test(config)# logging 10.229.255.15

hp-test(config)# logging facility local0

Recommendation:

Log events from all switches in the network that you manage on a common syslog server.

1.11

Basic SNMP Configuration

The example configuration assumes setting SNMPv1 and SNMPv2c for reading. This configuration is sufficient

for most monitoring applications. We simultaneously set up SNMP traps to addresses 10.229.255.14 and

10.229.255.15.

hp-test(config)# snmp-server host 10.229.255.14 "public"

hp-test(config)# snmp-server community "public" manager restricted

By default, for HP switches the public community is set to unrestricted. This means that it is possible to write

data to the MIB tree via SNMPv2.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sem comentários

HP HP ProCurve Series 6600 Manual do Utilizador Página 10