HP QX285USABA Manual do Utilizador descarregar pdf (Página 103)

Removing Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to

be removed before installing a drive. To remove a bezel blank:

1. Remove the access panel and front bezel.

2. To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards

the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it

(2).

Figure 4-4 Removing a Bezel Blank

Replacing the Front Bezel

Insert the three hooks on the bottom side of the bezel into the rectangular holes on the chassis (1)

then rotate the top side of the bezel onto the chassis (2) and snap it into place.

Figure 4-5 Replacing the Front Bezel

ENWW Removing Bezel Blanks 95

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 180 181

Sem comentários

HP QX285USABA Manual do Utilizador Página 103