HP Switch E42 Manual do Utilizador descarregar pdf (Página 34)

Model 5328A

Operation

3-47. SLOPE SWITCH. The ±SLOPE switch (provided for each channel) determines which slope

of the input signal will trigger the counter. As a simple example, (Figure 3-9) if the pulse width of a

positive pulse is to be measured, the A channel slope switch would be set to “+” and the B chan-

nel would be set to “-” (for time interval measurements the A channel always begins the mea-

surement and the B channel ends the measurement).

NOTE

A simple pulse width measurement is achieved with the use of the

+SLOPE setting for Channel A and the -SLOPE setting for Channel B.

Figure 3–9. Slope Switch Settings

3-48. LEVEL CONTROL. The LEVEL control for each channel is adjustable over the range of

±2.5V dc with the attenuator for that channel in the X1 position. A typical use of the LEVEL con-

trols is shown in Figure 3-10.

NOTE

Simple measurement of a time interval, the LEVEL control of the A

and B input channels were used to set the trigger LEVEL of A and B.

Figure 3-10. Level Control Settings

3-11

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 218 219

Sem comentários

HP Switch E42 Manual do Utilizador Página 34