HP Visualize b2000 - Workstation Especificações descarregar pdf (Página 140)

140 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

Memory Cards

2. Press downward on the ejector tabs located on both sides of the

DIMM connector. See Figure Figure 4-52. This raises the DIMM card

for easy extraction.

Figure 4-52 Removing Memory Cards

3. Lift up evenly on the outside edges of the DIMM card to remove it.

See Figure 4-52.

4. Install the remaining DIMM cards in the correct order. See Figure

4-47 or the system label.

5. Replace the left side panel as explained in the section “Replacing the

Left Side Panel” in this chapter. Plug the power cord back in to the

electrical outlet.

6. Verify that this removal was successful by following the steps in

Chapter 5, “The Boot Console Interface.” Note that you can also use

SAM and select the Performance Monitor icon, then the System

Properties icon, and in the window that appears, select the tab

labeled Memory.

Notches

Ejector Tab

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 228 229

Sem comentários

HP Visualize b2000 - Workstation Especificações Página 140