HP Visualize c240 - Workstation Manual de Serviço descarregar pdf (Página 205)

189

The Boot Console Interface

Displaying and Setting the Monitor Type

Your system ships from the factory preset to use a monitor with a speciﬁc

resolution and frequency. If you replace your workstation’s monitor with a

different type of monitor, you must reconﬁgure your workstation to support

the new monitor.

The Monitor Command

The monitor command lets you change your workstation’s graphics conﬁg-

uration. This command is available in Conﬁguration Menu of the boot con-

sole interface.

NOTICE: The monitor command lets you change your workstation’s graphics

conﬁguration before you replace your monitor. For information

about changing the conﬁguration after you replace your monitor,

refer to “Changing Your Monitor Type” in Appendix B.

To display the current graphics and console information, enter the following

command;

monitor

The correct usage for setting the graphics conﬁguration is:

monitor graphics_path type

where valid graphics_path parameters are:

graphics(0) - The built-in 8-plane graphics adapter.

graphics(1) through graphics(4) - Graphics adapters installed in option slots

1 through 4.

and type is the numerical monitor type

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 239 240

Sem comentários

HP Visualize c240 - Workstation Manual de Serviço Página 205