HP 4100GL Manual do Utilizador Página 67
- Página / 228
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
RADIUS Authentication and Accounting
Configuring the Switch for RADIUS Authentication
radius-server timeout < 1 .. 15 >
Specifies the maximum time the switch waits for a response
to an authentication request before counting the attempt as
a failure. (Default: 3 seconds; Range: 1 - 15 seconds)
radius-server retransmit < 1 .. 5 >
If a RADIUS server fails to respond to an authentication
request, specifies how many retries to attempt before closing
the session. Default: 3; Range: 1 - 5)
Note Where the switch has multiple RADIUS servers configured to support authen-
tication requests, if the first server fails to respond, then the switch tries the
next server in the list, and so-on. If none of the servers respond, then the switch
attempts to use the secondary authentication method configured for the type
of access being attempted (console, Telnet, or SSH). If this occurs, refer to
"RADIUS-Related Problems" in the Troubleshooting chapter of the Manage-
ment and Configuration Guide for your switch.
For example, suppose that your switch is configured to use three RADIUS
servers for authenticating access through Telnet and SSH. Two of these servers
use the same encryption key. In this case your plan is to configure the switch
with the following global authentication parameters:
Allow only two tries to correctly enter username and password.
Use the global encryption key to support the two servers that use the
same key. (For this example, assume that you did not configure these
two servers with a server-specific key.)
Use a dead-time of five minutes for a server that fails to respond to
an authentication request.
Allow three seconds for request timeouts.
Allow two retries following a request that did not receive a response.
Figure 3-5. Example of Global Configuration Exercise for RADIUS Authentication
3-13
- HP Procurve Series 4100GL 3
- Switches 3
- 2 TACACS+ Authentication 6
- Getting Started 13
- Introduction 14
- Command Syntax Conventions 16
- Simulating Display Output 16
- Related Publications 17
- Sources for More Information 20
- Need Only a Quick Start? 21
- Menu: Setting Passwords 26
- TACACS+ Authentication 29
- Software 31
- Release G.05. xx 31
- Terminology Used in TACACS 32
- Applications: 32
- General System Requirements 33
- Privilege Levels 35
- Before You Begin 37
- Configuration 38
- Caution Regarding 41
- Login Primary 41
- Note on 44
- Encryption Keys 44
- First-Choice TACACS+ Server 46
- How Authentication Operates 48
- Local Authentication Process 50
- Using the Encryption Key 51
- Access When Using TACACS+ 52
- Authentication 52
- Messages Related to TACACS+ 53
- Preparation: 59
- Want RADIUS To Protect 62
- The switch now 63
- SSH authentication 63
- Access When Using RADIUS 69
- IP address: 10.33.18.151 73
- Stop-Only: 75
- Start-Stop: 75
- Viewing RADIUS Statistics 77
- RADIUS Accounting Statistics 80
- Prerequisite for Using SSH 88
- Public Key Formats 89
- Host Public 96
- Key for the 96
- Bit size 97
- Exponent <e> 97
- Modulus <n> 97
- Client Contact Behavior 99
- Execute no ip ssh 100
- Public-Key Authentication 106
- Bit Size Exponent 107
- <e> 107
- Modulus 107
- <n> 107
- Comment 107
- Key Index 109
- Contents 113
- Overview 114
- Terminology 115
- Prerequisite for Using SSL 116
- Operation 119
- Password 120
- Security Tab 120
- Show host certificate 124
- Current SSL 127
- Host Certificate 127
- Browser Contact Behavior 129
- Enable SLL 132
- Common Errors in SSL setup 133
- (802.1x) 135
- Overview 136
- How 802.1x Operates 139
- as defined in the 142
- 802.1x standard 142
- Access Control (802.1x) 145
- Authenticators 148
- 802.1x Open VLAN Mode 154
- 802.1x Open VLAN Mode 155
- Unauthorized-Client VLANs 158
- 802.1x Devices 165
- Blocking a Non 166
- 802.1x Device 166
- Other Switches 167
- Statistics, and Counters 171
- The switch reboots 176
- After the 802.1x session 180
- Basic Operation 184
- • PC1 can access Switch A 186
- Planning Port Security 187
- Configuring Port Security 192
- Security Features 197
- Alert Flags 197
- Resetting Alert Flags 199
- Yes” for the port on which 201
- Options 209
- Access Levels 209
- Stations 210
- Managers 211
- Building IP Masks 215
- IP Entry 216
- Operating Notes 218
- Using Authorized IP Managers 219
- Index – 1 221
- 2 – Index 222
- Index – 3 223
- 4 – Index 224
- Index – 5 225
- 6 – Index 226
- 5990-3032 228
Manuais e produtos relacionados com Software HP 4100GL
Software HP rx3000 Series Manual do Utilizador
(301 páginas)
(301 páginas)
Software HP 39g+ Graphing Calculator Guia do Utilizador
(294 páginas)
(294 páginas)
Software HP 39g Graphing Calculator Guia do Utilizador
(288 páginas)
(288 páginas)
Software HP Vectra VE5 2 Guia do Utilizador
(102 páginas)
(102 páginas)
Software HP Photo Pro Guia do Utilizador
(16 páginas)
(16 páginas)
Software HP 5300 Informações Técnicas
(442 páginas)
(442 páginas)
Software Hp 9000 Servers Manual do Utilizador
(5 páginas)
(5 páginas)
Conceptronic C20-150 manuales
Manuales del propietario y guías del usuario para Hdd / ssd recintos Conceptronic C20-150.
Ofrecemos 1 manuales en pdf Conceptronic C20-150 para descargar gratis por tipos de documentos: Ficha de datos
Conceptronic C20-150 Ficha de datos (3 paginas)
Marca: Conceptronic | Categoria: HDD/SSD enclosures | Tamaño: 0.26 MB |
Tabla de contenidos
Más productos y manuales para Hdd / ssd recintos Conceptronic
| Modelos | Tipo de documento |
|---|---|
| C20-258 |
Ficha de datos
Conceptronic 2,5" Harddisk Box Mini Violet USB powered,
3 paginas
|
| C05-210 |
Ficha de datos
Conceptronic 3,5 inch USB hard disk box for SATA hard disk,
3 paginas
|
| C05-500 |
Ficha de datos
Conceptronic 2,5 / 3,5 inch hard disk docking station eSATA/USB,
3 paginas
|
| CHD3SATA |
Ficha de datos
Conceptronic Serial ATA External Hard disk box 3.5 “.,
1 paginas
|
| C10-393 |
Ficha de datos
Conceptronic Grab'n'GO 2.5” Hard Disk Box eSATA/USB 2.0,
3 paginas
|
| C05-326 |
Ficha de datos
Conceptronic USB SATA HDD 2.5" BLACK USB powered,
3 paginas
|
| C10-135 |
Ficha de datos
Conceptronic 3,5 inch USB/e-SATA hard disk box,
3 paginas
|
| C05-106 |
Ficha de datos
Conceptronic USB 2.0 & Firewire Harddisk Box 3.5",
1 paginas
|
| C05-324 |
Ficha de datos
Conceptronic 3,5 inch HardDiskBox DualBay,
3 paginas
|
| C20-253 |
Ficha de datos
Conceptronic 2,5" Harddisk Box Mini Blue USB powered,
3 paginas
|
| C05-209 |
Ficha de datos
Conceptronic 2,5 inch USB hard disk box for SATA hard disk,
3 paginas
|
| CHD3U |
Ficha de datos
Conceptronic USB 2.0 Hard Disk Box 3.5",
1 paginas
|
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais