HP 441877-00B Manual do Utilizador Página 83
- Página / 176
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Adapter configurations 83
o
Normal Behavior: The value will be used by the PHY detection routine to locate and initialize the
PHY. If a PHY is not found at the address specified, the driver will load but not function properly,
because PHY detection occurs after the initial load has occurred.
o Possible Errors: If the PHYADDRESS parameter is set to an invalid value, the parameter is ignored
and the default value is used, and a message indicates a "Parameter value out of range" error.
• SLOT
o Syntax: SLOT=[0x0..0x1FFF]
Optional unless you want to specify a particular adapter or module that is not loaded by default.
(By default, the driver loads on the first adapter it finds.)
o Example: SLOT=0x1C
o Default: The driver will Auto-Configure
o Normal Behavior: The driver uses the value of the parameter to decide which adapter to control.
o Possible Errors:
If only one adapter is installed and the value does not correctly indicate the adapter slot, a
message indicates that the value does not match the actual configuration, and the driver finds the
adapter and uses it.
If more than one adapter is installed and the value does not indicate the adapter slot, a message
displays indicating possible slots to use and the driver loads on the next available slot.
• NODE
o Syntax: NODE="12 hexadecimal digits"
The value must be exactly 12 hexadecimal digits, enclosed in double quotes
The value cannot be all zeros. The value cannot have the Multicast bit set (LSB of 2nd digit = 1).
o Example: NODE="00AA00123456"
o Default: Value from EEPROM installed on adapter
o Normal Behavior: The Current Station Address in the NDIS MAC Service-Specific Characteristics
(MSSC) table is assigned the value of this parameter. The adapter hardware is programmed to
receive frames with the destination address equal to the Current Station Address in the MSSC
table. The Permanent Station Address in the MSSC table will be set to reflect the node address
read from the adapter's EEPROM.
o Possible Errors: If any of the rules described above is violated, an error message indicates the
rules for forming a proper address, and the driver treats this as a fatal error.
• CONGENB
o Syntax: CONGENB=[0 | 1]
o Example: CONGENB=1
o Default: Congestion Control is disabled.
o Normal Behavior: The absence of this parameter or the value 0 results in no Congestion Control.
The value of 1 enables the Congestion Control feature.
o Possible Errors: If the CONGENB parameter is set to an invalid value, the parameter is ignored
and the default value is used, and a message indicates a "Parameter value out of range" error.
• RXFIFO
o Syntax: RXFIFO=[0..15 | 0x0..0xF]
o Example: RXFIFO=8
- HP Network Adapter 1
- Contents 3
- Contents 4 4
- Overview 5
- Overview 6 6
- Overview 8 8
- PCI Hot Plug 9
- Duplex support 10
- • Syntax: FORCEDUPLEX=n 11
- Overview 12 12
- Installation 13
- Windows 2000 and Windows NT 15
- • PROTOCOL.INI 17
- • SYSTEM.INI 18
- • AUTOEXEC.BAT 19
- • UNATTEND.TXT 19
- SCO OpenServer and UnixWare 21
- NetWare 28
- Installation 32 32
- Installation 35 35
- Installation 36 36
- Installation 37 37
- Installation 38 38
- Installation 39 39
- Installation 40 40
- Installation 41 41
- Installation 42 42
- Installation 43 43
- • TX_ECBS_TO_USE 47
- • VLANID 47
- Firmware upgrade utility 48
- Firmware upgrade utility 49 49
- Linux utility 54
- DOS utility 59
- Firmware upgrade utility 61 61
- Adapter configurations 62
- • [Q57] 63
- • [Q57_1] 63
- • [Q57_2] 63
- • [Q57_3] 63
- Adapter configurations 65 65
- Accelerated iSCSI devices 66
- Adapter configurations 68 68
- HP NC-Series Intel adapters 69
- Adapter configurations 70 70
- • 0–Success 74
- • 1–Operator termination 74
- • 2–Invalid adapter 74
- • 4–EEPROM checksum failure 74
- Adapter configurations 75 75
- Adapter configurations 76 76
- Adapter configurations 77 77
- Adapter configurations 78 78
- 79
- / Acronym 80
- Definition 80
- Term / Abbreviation 80
- • DRIVERNAME 81
- • SPEED 82
- • FORCEDUPLEX 82
- • PHYADDRESS 82
- • SLOT 83
- • NODE 83
- • CONGENB 83
- • RXFIFO 83
- • TXFIFO 84
- • TXTHRESHOLD 84
- • RXDMACOUNT 84
- • TXDMACOUNT 85
- • TRANSMITBUFFERS 85
- • RECEIVEBUFFERS 85
- • MCWA 86
- • FRAMEGAP 86
- • CACHEFLUSH 86
- • SPEEDDUPLEX 87
- • DRIVERNAME parameter 88
- • NODE parameter 88
- • SLOT parameter 88
- • CACHEFLUSH parameter 89
- • A Windows® environment 89
- • A DOS environment 89
- Windows 91
- Novell Netware 110
- Adapter configurations 112 112
- Adapter configurations 113 113
- Adapter configurations 114 114
- Adapter configurations 115 115
- Adapter configurations 116 116
- • Example 6: VLAN with QASP 117
- • Example 8: GVRP with QASP 117
- • TxDescriptors= 118
- • RxBuffers= 118
- • Speed= 118
- • Link= 118
- • RxTicks= 118
- Installing Client 32 on DOS 120
- NET.CFG parameters 120
- • Example NET.CFG 121
- • Example CONFIG.SYS 121
- Solaris 122
- Adapter configurations 123 123
- Adapter configurations 124 124
- Adapter configurations 125 125
- Team properties 126
- Team properties 127 127
- Team properties 128 128
- Team properties 130 130
- NetWare teaming 139
- • CPQANS STATUS 141
- • CPQANS PRIMARY 141
- VLAN properties 150
- ProLiant Essentials 151
- ProLiant Essentials 153 153
- Diagnostics 154
- Diagnostics 156 156
- Diagnostics 158 158
- Diagnostics 159 159
- • -I <num> 162
- • -ver 162
- • -bus <num> 162
- Diagnostics 168 168
- Diagnostics 169 169
- Diagnostics 170 170
- Technical support 172
- Technical support 173 173
- Acronyms and abbreviations 174
- Index 176 176
Manuais e produtos relacionados com Software HP 441877-00B
Software HP 200 Manual do Utilizador
(676 páginas)
(676 páginas)
Software HP PROCURVE W.14.03 Manual do Utilizador
(594 páginas)
(594 páginas)
Software HP T8671-91017 Manual do Utilizador
(54 páginas)
(54 páginas)
Software HP MT40 Guia do Utilizador
(74 páginas)
(74 páginas)
Software HP 4100GL Manual do Utilizador
(228 páginas)
(228 páginas)
Software HP rx3000 Series Manual do Utilizador
(301 páginas)
(301 páginas)
Software HP 39g+ Graphing Calculator Guia do Utilizador
(294 páginas)
(294 páginas)
Software HP 39g Graphing Calculator Guia do Utilizador
(288 páginas)
(288 páginas)
Software HP Vectra VE5 2 Guia do Utilizador
(102 páginas)
(102 páginas)
Software HP Photo Pro Guia do Utilizador
(16 páginas)
(16 páginas)
Software HP 5300 Informações Técnicas
(442 páginas)
(442 páginas)
DeVilbiss COMPACT P2-11 manuály
Uživatelské manuály a uživatelské příručky pro Stříkací barva DeVilbiss COMPACT P2-11.
Poskytujeme 2 manuály pdf DeVilbiss COMPACT P2-11 ke stažení zdarma podle typů dokumentů: Uživatelský manuál, Specifikace
Comentários a estes Manuais