HP M208 Manual do Utilizador descarregar pdf (Página 121)

USING THE M208’S COMMAND SET: npsh Command Set 113

[-]bbmode Simulate an attached printer even if a printer isn’t really

there.

[-]fastmode Increase transfer rate.The parallel interface of the attached

printer must be able to support this increased rate and if using

this mode, use only with short (less than two meter) low-

capacitance cabling.

[-]onlcr Enable [disable] carriage return insertion.

[-]opost Allow output processing such as onlcr, xtab, and descram-

bling. With “-”, do not allow any of this processing.

[-]slowmode Slow the transfer rate to match that of a PC’s parallel port.

Might be necessary with older, slower laser printers.

[-]vslowmode Slow the transfer rate even more to accommodate certain

printers.

flush Flush the data in the parallel I/O port’s output buffer.

unlock Release the access lock on the parallel I/O port.

Caution

Using the unlock option when an I/O port is active can cause output from two

jobs to intermix.

set prn timeout <

INT

Terminate a print job sent to the parallel I/O port if it is not printed after the

timeout period (INT is time in minutes). If the timeout is set to zero (0), the

timeout feature is also disabled.

Printer errors will cause the M208 to postpone printing until the printer is

ﬁxed regardless of this timeout feature being set or not. Therefore, no data

will be lost.

Note

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 223 224

Sem comentários

HP M208 Manual do Utilizador Página 121