HP DL380-SL Guia do Utilizador descarregar pdf (Página 122)

Chapter 3: mx Commands 111

--repositoryPercentOfBase

The snapshot process creates a repository on disk that stores pointers to the

data in the source filesystem. As changes are made to the filesystem,

subsequent snapshots will copy the changed data to the repository. This

option asks for the initial size of the repository. The size is specified as a

percentage of the volume holding the filesystem. The default is 20% of the

base volume.

mx vfs – Virtual CIFS Server commands

Use the following mx vfs commands to configure Virtual CIFS Servers or to

display their status.

add—Add a new Virtual CIFS Server

mx vfs add [--policy autofailback|nofailback] [--application

<application name>] <ip> <name> ALL_SERVERS <primary network

interface>| <network interface> ...

<ip> <name> asks for the IP address and hostname for the Virtual CIFS Server.

The hostname can include up to 32 characters.

If you specify ALL_SERVERS, the Virtual CIFS Server will be defined on all of

the servers. You will also need to specify the primary interface for the Virtual

CIFS Server, as it determines the order of the interfaces for failover.

If the Virtual CIFS Server should be defined only on certain nodes, you can

specify the appropriate network interfaces on those nodes. The order in

which you specify the network interfaces determines the ordering for failover.

The first network interface is the primary interface; network traffic for the

Virtual CIFS Server goes to the node providing this interface. The remaining

network interfaces are backups. Each network interface must be located on a

different node.

NOTE: If a Virtual CIFS Server is configured with ALL_SERVERS, any new

nodes added to the cluster are also added automatically to the Virtual

CIFS Server. The HP Management Console does not specify whether a

Virtual CIFS Server has been configured with

ALL_SERVERS. In

addition, you cannot use the Properties or Rehost options on the HP

Management Console to remove a node from a Virtual CIFS Server

configured with

ALL_SERVERS. Instead, you will need to use the mx

vfs update command to reconfigure the Virtual CIFS Server on the

appropriate nodes.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 140 141

Sem comentários

HP DL380-SL Guia do Utilizador Página 122