Hp Identity Driven Manager Software Series Manual do Utilizador descarregar pdf (Página 77)

3-9

Using Identity Driven Manager

Configuring Locations

7. Use the Port Selection to define the ports on the device that will be

associated with the location.

• Click to select Any port on the switch, or

• Click Select ports, then use the pull down lists to select the Begin and

End ports on the device that will be associated with the new location.

If you manually entered the device address, the

Begin port and End port

pull-down menus are disabled, and you must manually enter the ports.

8. Click Ok to save the New Device settings to the Location, and close the

window.

NOTE: If a switch in the device list is not configured to authenticate with the RADIUS

server, the settings in IDM will have no affect.

You can type in an IP address for non-ProCurve devices and if the device uses

industry standard RADIUS protocols, the settings should work; however, HP

does not provide support for IDM configurations with non-ProCurve devices.

9. The Device address and ports information is displayed in the

New Location

window.

10. Repeat steps 4 through 7 to add additional devices to the Location, or click

OK to save the new Location and close the window.

To Add a Wireless Device to a Location:

11. Click the Wireless devices tab:

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 199 200

Sem comentários

Hp Identity Driven Manager Software Series Manual do Utilizador Página 77