HP Imaging and Printing Security Center Guia do Utilizador descarregar pdf (Página 31)

Assess and remediate

After you add devices and create policies, you are ready to run an assessment of the devices within

the selected device group. You can schedule the assessment to run immediately or to run in the

future. The assessment identifies the devices in your network that do not comply with your security

policy. If you choose to remediate, devices with noncompliant settings are corrected.

NOTE: If Allow Automatic Remediation is enabled, automatic remediation of the device occurs

automatically. For more information, see

Set up Instant-On Security on page 12

Before running the first assessment, verify the global remediation setting. See

Verify global

remediation setting on page 9.

Some policy items cannot be remediated. The item might be dependent on another setting or it

cannot be changed on the device. See the item's information bubble for details about the restriction.

Remediation options are also set by the policy using the Advanced Policy Settings. See

Set

severity, remediation, and unsupported behavior on page 18 for more information.

When scheduling an assessment, you can select to Assess Only, which provides a report, but does

not change any device settings, or Assess and Remediate, which remediates out-of-compliance

devices.

Schedule an assessment/remediation

You can run an assessment/remediation from the Devices tab, the Policies tab, or from the Tasks

tab.

●

Run an assessment/remediation from the Devices tab

●

Run an assessment/remediation from the Policies tab

●

Run an assessment/remediation from the Tasks tab

Run an assessment/remediation from the Devices tab

To run an assessment from the Devices tab:

1. Start the HP Imaging and Printing Security Center and click the Devices tab.

2. Right-click the device group and select Assess Only or Assess and Remediate. Or, click

Action and then select Assess Only or Assess and Remediate from the menu.

3. Enter a Task Name for the assessment so you can identify it later.

4. Select the Policy to use for the assessment.

NOTE: You cannot select an invalid (incomplete) policy for an assessment.

5. Click Select in the Device Group field to change the group.

6. Enter the Start Date, Start Time, and Frequency, or use the defaults.

7. Click OK to schedule the assessment or Cancel to discard your entries.

8. Click the Tasks tab to monitor your task. (Click the Refresh button to update the display.)

ENWW Assess and remediate 27

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Sem comentários

HP Imaging and Printing Security Center Guia do Utilizador Página 31