HP NAS 8000 Non-Clustered Solution Guia do Utilizador descarregar pdf (Página 10)

8 Command Reference

getNetworkCardDhcpEnabled

Identifies whether the specified NIC is DHCP enabled.

When DHCP is enabled, NIC configuration occurs automatically. Depending on your

configuration, the DHCP server provides any or all of the following parameters: IP Address,

Subnet Mask, Gateway Address, Broadcast Address.

■

inParam[0] = Network card name

■

outParam[0] = T (Enabled) or F (Disabled)

setNetworkCardDhcpEnabled

Enables or disables DHCP for the specified NIC. If DHCP is disabled, the NIC IP address must be

manually defined.

■

inParam[0] = Network card name

■

inParam[1] = T (Enable) or F (Disable)

getNetworkCardEnabled

Identifies whether the specified NIC is enabled.

■

inParam[0] = Network card name

■

outParam[0] = T (Enabled) or F (Disabled)

getNetworkCardGatewayAddress

Returns the gateway address for the specified NIC.

■

inParam[0] = Network card name

■

outParam[0] = Gateway address

setNetworkCardGatewayAddress

Sets the gateway address for the specified NIC.

■

inParam[0] = Network card name

■

inParam[1] = Gateway address

getNetworkCardInterfaceName

Returns the name for the specified NIC.

■

InParam[0] = Network card (NIC)

■

OutParam[0] = Name

getNetworkCardIpAddress

Returns the IP address for the specified NIC.

■

inParam[0] = Network card

■

outParam[0] = IP address

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Comentários a estes Manuais

Sem comentários

HP NAS 8000 Non-Clustered Solution Guia do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP NAS 8000 Non-Clustered Solution