HP StorageWorks 9030 Virtual Library System Manual do Utilizador descarregar pdf (Página 94)

LED stateLEDLocationItem

OnPower On/OK (green)5

OnSAS Out port status (green)6

Figure 6 VLS9200 Capacity Enclosure Rear Panel LED Status – Normal Operation

LED stateLEDLocationItem

OffVoltage/Fan Fault/Service Required (amber)Power module1

OnInput Source Power Good (green)2

OffUnit Locator (white)Expansion controller3

OffOK to Remove (blue)4

OnFRU OK (green)5

OffFault/Service Required (amber)6

OnSAS In Port Status (green)7

OnSAS Out Port Status (green)8

Powering On the VLS System

To power on the system:

1. Power on the two private LAN switches connected to the VLS. (VLS9000 7.5 TB and 10 TB

systems only include one LAN switch.)

2. Power on the two private Fibre Channel switches connected to the VLS. (VLS9000 7.5 TB and

10 TB systems do not include Fibre Channel switches.)

3. Power on all arrays in the VLS. See “Powering on VLS Arrays” (page 91).

4. Press the Power On/Standby button on all of the secondary nodes.

5. After the secondary nodes are powering up, press the Power On/Standby button on the

primary node.

6. Confirm that the VLS components are all functioning normally and the VLS is cabled correctly

by observing their status LEDs.

The LED status should match those shown in the following table. If it does not, a component

needs attention.

94 Operation

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 267 268

Sem comentários

HP StorageWorks 9030 Virtual Library System Manual do Utilizador Página 94