HP X9300 Guia de Instalação descarregar pdf (Página 53)

8. The wizard now validates the information you have entered. It performs the following tests:

• Pings the active OA.

• Verifies the OA password.

• Verifies that that OA at that IP address is the active OA.

If any of these tests fail, verify the configuration of the OA and VC modules as described on

the failure report displayed on the GUI. If you need to re-enter the IP address for the OA, select

Back to return to the Confirming Onboard Administrator and Virtual Connect Settings dialog

box, where you can make your changes.

NOTE: If the initialization of the credential manager fails, the GUI displays a message asking

you to initialize the credential manager manually. See “Credential Manager initialization

failed” (page 76) for more information.

9. The wizard now verifies the OA firmware.

10. Set the iLO IP addresses. On the Get iLO IP Addresses dialog box, select the method you want

to use to set up iLO IP addresses. Use the space bar to select/deselect the check boxes.

To configure the iLO IP addresses in sequence, enter the first iLO IP address on the Set iLO IP

Addresses dialog box. For example, if 172.16.3.1 is the starting iLO IP address, the installer

sets the iLO IP addresses in the range 172.16.3.1 to 172.16.3.16 by incrementing 1 to the

last octet of the IP address.

Starting the installation and configuring the chassis 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 150 151

Sem comentários

HP X9300 Guia de Instalação Página 53