Hp 3PAR Remote Copy Software Manual do Utilizador descarregar pdf (Página 77)

3.15

Setting the Remote Copy Transport Layer

InForm OS Version 2.3.1 Remote Copy User’s Guide

3 Verify the Fibre Channel transports are present on the Fibre Channel adaptor ports on each

system and the

State column displays ready by issuing the showrctransport -rcfc

command.

4 Initialize the Fibre Channel adaptor ports on each storage server as shown in the following

example:

5 Issue the

showrctransport -rcfc command on each system again to verify that the

Fibre Channel adaptor ports are ready to begin setting up Remote Copy.

6 If any port displays that the

RCFC State is incomplete or new, repeat steps 3 and 4 until

the State column displays ready as shown in the following example.

3.4.4 Setting Up RCFC Over an IP Network

To set up RCFC connections communicating over an IP network:

1 Set up Fibre Channel over IP on your network switches. Refer to your switch manufacturer’s

documentation for instructions.

2 Set up the InServ Storage Servers as described in Setting Up Remote Copy Over Fibre

Channel on page 3.13.

# showrctransport -rcfc

N:S:P Peer_Node_WWN Peer_Port_WWN State

3:2:1 2FF70002AC00005F 23410002AC00005F new

1:4:1 2FF70002AC00005F 21510002AC00005F new

# controlport rcfc init -f <N:S:P>

# showrctransport -rcfc

N:S:P Peer_Node_WWN Peer_Port_WWN State

3:2:1 2FF70002AC00005F 23410002AC00005F ready

1:4:1 2FF70002AC00005F 21510002AC00005F ready

NOTE: RCFC over IP networks is only allowed for Remote Copy in asynchronous

periodic mode. See Asynchronous Periodic Mode on page 2.24.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 343 344

Sem comentários

Hp 3PAR Remote Copy Software Manual do Utilizador Página 77