Hp Command View for Tape Libraries Software Manual do Utilizador descarregar pdf (Página 146)

4. Select the robotics or drives to be added to the ACG, then click Next.

NOTE: If you are using Basic Secure Manager, all the devices in the library will be selected

and the wizard will be grayed out. Your single ACG will have full access to all devices in the

library.

If you are using Advanced Secure Manager (license required), individual devices can be

selected, and more than one ACG can be created.

To separately configure each FC Port or LUN for each device, click Customize Port/LUN

settings at the bottom of the wizard screen. When checked, individual FC Ports and LUNs

can be selected for each device.

NOTE: For LTO3 and earlier tape drives, the FC port/LUN combinations must be unique for

each device, and this is validated when completing the next step. For LTO4 and later tape

drives, select FC Port 0 if the FC cable is connected to port A on the tape drive or FC Port 1

if the FC cable is connected to port B. The LUN will always be 0 for LTO4 and later drives.

146 Advanced features in the GUI

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 275 276

Sem comentários

Hp Command View for Tape Libraries Software Manual do Utilizador Página 146