Hp D2D100 Backup System Manual do Utilizador descarregar pdf (Página 30)

1. If you have already powered up the HP D2D Backup System, power it down and disconnect the

cables before you start.

2. Remove the access panel from the HP D2D B a ckup System.

3. Install the HBA.

4. Install an internal tape drive and connect it to the HBA (if required).

5. Replace the access panel on the HP D2D Backup System.

6. Connect an external tape drive (if required).

Please refer to the “User Guide” that is supplied with the tape drive for more detailed information about

tape drive cabling and LED troubleshooting.

Removing the access panel and bezel

1. If you are ins

talling the tape drive as p art of the initial installation, go to step 3. If you have already

powered on t

he HP D2D Backup System, it must be shut down before you start. Make sure there

are no backup or restore jobs in progress and that no future jobs are scheduled to start whilst the

system is shut down. Select Shutdown on the Web Management interface a nd click Power Off to

power down the HP D2D Backup System safely.

2. Disconne

ct the network cable and the power cord from the HP D2D Backup System.

3. Loosen the captive thumbscrew (1) located on the rear edge of the access panel and slide (2)the

panel back about 2.5 cm (1.0 in). Remove the access panel.

Figure 11 Removing the access panel

4. Pressinonthetwobottomtabs(1) on the side of the bezel so that they release from the chassis.

Press in on the upper tab on the side of the bezel so that it releases from the chassis. The bezel will

rotate o ut slightly (2). Pull the bezel away from the front panel (3).

Attaching a physical tape drive (optional)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 125 126

Sem comentários

Hp D2D100 Backup System Manual do Utilizador Página 30