Hp Hitachi Dynamic Link Manager Software Manual do Utilizador descarregar pdf (Página 120)

100

101

3. Creating an HDLM Environment

• To allocate the HDLM device for each LU, execute the following command:

zonecfg:zone1:device> set match=/dev/rdsk/

c5t50060E800436E211d0*

• To allocate the HDLM device for each controller, execute the following

commands, and then restart the non-global zone:

zonecfg:zone1:device> set match=/dev/rdsk/c5t*

zonecfg:zone1:device> end

zonecfg:zone1> verify

zonecfg:zone1> commit

zonecfg:zone1> exit

For details on the commands, refer to the Solaris 10 documentation.

Table 3-18: Support for the Solaris zones shows the HDLM support for the

Solaris zones.

Table 3-18: Support for the Solaris zones

 When performing a new installation or upgrade installation of HDLM using the

pkgadd command, respond as follows when the message output by the pkgadd

command prompts you to enter information:

• When you want to continue the installation, respond to all prompts by

entering

• When you want to interrupt or stop the installation, respond by entering

 Before you perform the following operations in an environment whose run level

is less than 2, execute the procedure described in (1) Initializing HDLM When the

Host Is Started in Single-User Mode in 4.1.9 Operation in Single-User Mode:

• Installing HDLM

Item Global zone Non-global zone Remarks

Installing HDLM Supported Not supported --

Path operations Supported Not supported --

Displaying path statuses Supported Not supported --

Accessing HDLM devices Supported Supported The devices must be

allocated to the relevant

zone.

Uninstalling HDLM Supported Not supported --

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 651 652

Comentários a estes Manuais

Sem comentários

Hp Hitachi Dynamic Link Manager Software Manual do Utilizador Página 120

Comentários a estes Manuais

Manuais e produtos relacionados com Armazenamento Hp Hitachi Dynamic Link Manager Software