Hp Storage Mirroring V4.5 Software Manual do Utilizador descarregar pdf (Página 129)

10 - 5

Verify target data viability

After you have configured your servers, you can use the Application Manager to run a test that

verifies that the database on the target is viable for failover. One benefit of performing the verification

test is that you do not have to perform an additional remirror or failover to verify target data viability.

In order to perform target data verification, the following prerequisites must be met:

 The target server must be running Windows 2003, Service Pack 1 or later.

 Target data verification cannot be used on Exchange clusters.

 If the current volumes do not have adequate space to contain the snapshots, modify the

properties for the Shadow Copies settings on each volume to set the storage location of the

snapshots where the data resides.

 Target path blocking must be disabled for the connection in the Storage Mirroring Management

Console.

 The Storage Mirroring disk queue cannot be located on a volume that will be reverted. To use

target data verification, you must first update the queue setting in Storage Mirroring Management

Console, then restart the Storage Mirroring service.

 For Exchange, if you are running the Application Manager from any server other than the source

or target, you must install the Exchange System Manager component on that client (due to a

dependency on the

cdoexm.dll file).

 For SQL, target data verification is only supported in instance mode. It is not available for

database-only mode.

While in verification mode, Storage Mirroring will queue on the target in the directory you selected

during Storage Mirroring configuration. You should be aware of your data change rate and make sure

you have adequate capacity on the volumes configured for the Storage Mirroring target queues. For

more information, see the Storage Mirroring User’s Guide.

Target path blocked Target pat h blocking is enabled for the connection

(Unknown) Target status could not be determined

NOTE: Target data verification can only be used with Exchange and SQL.

NOTE: You can also verify target data viability from a command line interface. The

TDV.exe

utility is available from the

DT_Utilities folder. For more information about using the

target data verification command line utility, see Using the Target Data Verification

(TDV) Utility on page F-1.

Target Status Description

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 162 163

Sem comentários

Hp Storage Mirroring V4.5 Software Manual do Utilizador Página 129