Hp StorageWorks 2405 Disk System Manual do Utilizador descarregar pdf (Página 63)

Installation 63

Installation

Install the Disk System

1 Remove the power supply/fan modules to prepare the disk system for lifting:

a Loosen the screws in the extractor handles of each power supply/fan

module with the chassis still in the box.

b Pull the extractor handles out from the center of the power supply to

disengage it from the midplane. Pull each power supply/fan module out of

the chassis. Support the far end of the power supply/fan module with your

free hand as it clears the chassis.

c Set the power supply/fan modules aside, on an antistatic pad, to be

reinstalled later.

WA RN IN G An empty disk system weighs approximately 54 pounds (24.5 kg).

To avoid personal injury, it is recommended that two people install

the storage device in the rack.

2 Remove the disk modules from the disk system. Place them aside on the pink

antistatic foam pad supplied with your disk system.

3 Carry the disk system to the front of the rack and slide the back end onto the

rails (Figure 35) with the help of another person or using a lifting device.

Push the disk system into the rack as far as it will go.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 143 144

Sem comentários

Hp StorageWorks 2405 Disk System Manual do Utilizador Página 63