Hp StorageWorks EVA Controller HSG V8.8 Software Manual do Utilizador descarregar pdf (Página 34)

About SWCC

34 Command Console V2.5 User Guide

Network Connections

Using SWCC with a network connection provides you with more features and

flexibility for managing storage subsystems than serial or SCSI connections. A

network connection between a client and agent supports the use of the Navigation

tree, allowing for the management of multiple subsystems from a single

application. The use of an agent enables event logging on the agent host and also

email and pager notification for subsystem events.

A network connection requires that an agent be installed on a host connected to

the storage subsystem. Establishing a network connection requires that a

Command Console LUN or a virtual disk be configured on the storage subsystem.

If the storage subsystem is not properly preconfigured, then a serial connection

must be used to enable the Command Console LUN or to create a virtual disk.

To use SWCC to manage the HS-Series controller over a network, install the

Command Console, the HS-Series device-specific Client (Storage window), and

the HS-Series Agent. The Command Console and the HS-Series Client are

installed together.

To set up SWCC to manage the HS-Series controller over a network:

1. Click Start > Programs > Command Console > StorageWorks CC HSxxx.

The Client displays the Connection Selection window.

2. Choose the Network (TCP/IP).

The Connect Network (TCP/IP) window opens, as shown in Figure 7.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 149 150

Sem comentários

Hp StorageWorks EVA Controller HSG V8.8 Software Manual do Utilizador Página 34