Hp XP7 Storage Manual do Utilizador descarregar pdf (Página 35)

DS P,device_unit_ID

The following figure shows a sample output of this command.

DEVSERV QPAV commands

You can use the MVS DEVSERV QPAV commands to complete the following operations:

• Show the status of PAV base devices.

For more information about showing the status of PAV base devices, see (page 35).

• Show the status of a HPAV base device and its alias devices.

For more information about showing the status ofHPAV base devices and its alias devices,

see (page 35).

• Show the SSID status.

For more information about showing the status of an SSID, see (page 36).

• Show the status of the host and subsystem configuration.

For more information about showing the host and subsystem configuration status, see (page 37).

Showing the PAV base device status

Use this task to the status of PAV base devices.

Run this command using the following syntax:

DS QP,device_unit_ID,4

The following figure shows a sample output of this command.

Showing the status of HPAV base devices and alias devices

Use the following task to show the status of a HPAV base device and its alias devices.

Run this command using the following syntax.

DS QP,device_unit_ID,HPAV

The following figure shows a sample output of this command.

HP Confidential MVS commands to monitor Parallel Access Volumes 35

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 52 53

Sem comentários

Hp XP7 Storage Manual do Utilizador Página 35