Hp 6627A Manual do Utilizador descarregar pdf (Página 81)

Remote Operation 81

HARDWARE ERR 10 An output error has occurred in an unknown output. Service is required.

HDW ERR CH 1 11 Errors 11 through 14 refer to a specific output where there is an output error.

Service is required.

HDW ERR CH 2 12 Same as in Error #11

HDW ERR CH 3 13 Same as in Error #11

HDW ERR CH 4 14 Same as in Error #11

NO MODEL NUM 15 The interface cannot find its model number. There may be a hardware failure

or the instrument may require reprogramming. Service is required.

CAL ERROR 16 You tried to use either a calibration command with CMODE off or the

calibration failed while in CMODE. Enable CMODE and check numbers sent

during calibration. Also, there could be a hardware error.

UNCALIBRATED 17 There is an incorrect checksum in the EEPROM possibly as a result of

incorrect calibration procedure. Recalibrate, and if the problem persists, your

supply has a hardware failure.

Table 5-8. Error Messages (continued)

Front Panel

Response

HP-IB

Code

Explanation

CAL LOCKED 18 Calibration was attempted with the Calibration Jumper on the HP-IB board in

the lockout position. Reposition jumper if desired. See Service Manual.

SKIP SLF TST 22 The self test jumper on the HP-IB board is in the Skip Self Test position. No

self-test was done. This is for diagnostics only. See Service Manual.

Table 5-9. TEST? Responses

Code Explanation

0 This is the response to the TEST? query when there are no errors.

20 The timer has failed self-test. Refer to the troubleshooting section in the Service Manual.

21 The RAM has failed self-test. Refer to the troubleshooting section in the Service Manual.

27 The ROM has failed the checksum test. Refer to the troubleshooting section in the Service Manual.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 114 115

Sem comentários

Hp 6627A Manual do Utilizador Página 81