HP RP7 Manual do Utilizador descarregar pdf (Página 14)

This apparatus is intended to be supported by UL or CSA Listed wall mount bracket. HP recommends

that you use an HP Quick Release mounting bracket for wall mounting (part number EM870AA).

CAUTION: To attach a third-party mounting solution to the RP7, four 4 mm, 0.7 pitch, and 10 mm

long screws are required. Longer screws must not be used because they may damage the system. It

is important to verify that the manufacturer’s mounting solution is compliant with the VESA standard

and is rated to support the weight of the system.

Installing the RP7 Adjustable Stand

NOTE: This section provides instructions for installing the RP7 Adjustable Stand if the stand was

purchased separately.

1. Turn off the computer properly through the operating system, then turn off any external devices.

2. Disconnect the power supply from the rear I/O connector and from the power outlet.

CAUTION: Regardless of the power-on state, voltage is always present on the system board

as long as the system is plugged into an active AC outlet. You must disconnect the power cord

to avoid damage to the internal components of the computer.

3. Disconnect all cables from the rear I/O connectors.

8 Chapter 2 Hardware Upgrades ENWW

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 72 73

Sem comentários

HP RP7 Manual do Utilizador Página 14