HP FB910 Guia do Utilizador descarregar pdf (Página 9)

4 Chassis preparation

4.1 Required tools and materials

 Forklift with 45" long (about 144 cm) forks that span up to 42" (about 107 cm) wide

 13mm wrenches (2) or sockets (2)

 Polyurethane foam blocks 2-3" thick

 Shrink/stretch wrap or other shipping materials

 Saran™ Wrap (genuine Saran brand recommended; other plastic films may react with the ink)

 Cable ties or rubber bands

When properly installed, the printer rests on leveling pads. If the printer is to be moved entirely by

forklift or other rigging, it may not be necessary to remove the pads and install the wheels. If wheels

are necessary or desired for the move, the following is required:

 Printer wheels, quantity 4, HP Part number CH971-91440 FRM,PRNTR_WHEEL,L if the

original wheels are no longer on hand. This kit includes one wheel and the necessary

hardware to attach it to the printer.

4.2 Procedure

1. Disconnect the user-end and service-end enclosures from the rest of the printer.

Figure 10 Service-end cable connections

Figure 11 Service-end grounding strap (user end similar)

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

HP FB910 Guia do Utilizador Página 9