HP Model 743 PC Manual do Utilizador descarregar pdf (Página 48)

2-10

Accessories Installation

GSC Mezzanine Cards

Installing GSC Mezzanine Cards

This section provides step-by-step instructions for installing GSC mezzanine

cards into your Model 743.

Preliminary Requirements

Perform the following steps before you install a GSC card:

1 The Model 743 must already have a GSC expansion kit installed.

2 If the Model 743 board computer is already installed in your system card

cage, you must remove it. See Chapter 3 of this book for instructions on

removing and replacing the Model 743 board computer from its chassis.

3 Place the Model 743 board computer on a static free mat on a clean, level

surface.

GSC Mezzanine Card Installation

Follow these steps to install a GSC card into your Model 743 Board Com-

puter:

1 Working from the back of the Model 743 Board Computer, you can install

GSC graphics cards into either the right-hand or center position shown in

Figure 2-4.

2 Using Figure 2-4 as a guide, position a card and line up its connector over

the GSC connector on the board computer.

3 Press the card down to seat the connectors.

4 Insert the two M2.5x6 screws that hold the GSC card to the adapter fixture

and screw into place.

5 Insert the two M2.5x5 screws that hold the card to the front panel expan-

sion plate and screw into place.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 141 142

Sem comentários

HP Model 743 PC Manual do Utilizador Página 48