HP OMNIBOOK 800 Manual do Utilizador descarregar pdf (Página 13)

Starting Out with Your OmniBook

Setting Up the OmniBook

1-7

4. Reset the OmniBook.

• Press the reset button: Insert a pen tip or bent paper clip into the small

opening marked “RESET” on the right side of the computer. Press the

recessed button for 1 to 2 seconds. The OmniBook may take half a minute

or more to restart (reboot).

Pressing the reset button is similar to turning off a PC’s power, then turning it

back on again. After this first time, you should not need to press the reset button

often.

If you have an OmniBook floppy drive attached when you reset the OmniBook,

make sure there’s no disk in the drive (unless you set the option in the System

Configuration Utility to boot only from the hard drive). As on a PC, if there’s a

disk in the floppy drive, the OmniBook looks there first for its startup files.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 87 88

Sem comentários

HP OMNIBOOK 800 Manual do Utilizador Página 13