HP Retail Jacket for ElitePad Manual do Utilizador descarregar pdf (Página 25)

【Enter Setup】

**【Exit Setup】 14

Scan Mode

 Level Mode: Lighting and decoding are on when the trigger is active and off otherwise.

 Presentation Mode: Lighting and decoding are on from power-on and lighting turns off after One Reading Timeout

(See the “Reading Timeout and Reread Delay” section on Page 15). When a new bar code is presented lighting

and decoding restart until timeout occurs again. Reread Delay (See the “Reading Timeout and Reread Delay”

section on Page 15) can prevent undesired multiple reads of the same label while in this mode. Sensitivity (See the

“Sensitivity” section on Page 18) can change the Presentation Mode’s sensitivity to light.

 Continuous Mode: The scanner is always active from power-on. Pull the trigger will change the scanner status.

Reread Delay can prevent undesired multiple reads of the same label while in this mode.

 Pulse Mode: When the trigger is pulled, scanning is activated until a bar code is decoded or One Reading Timeout

elapses.

 Toggle Mode: The aimer turns on when the trigger is activated and decoding begins when the trigger is released.

The scanner will terminate scan status after One Reading Timeout.

 Flashing Mode: The scanner flashes on and off regardless of the trigger status. Flash rate is controlled by Flash On

Time and Flash Off Time (See the “Flash On/Flash Off Time” section on Page 17). When Flash is ON the scanner

reads c ontinuously. When Flash i s O FF s canning is dea ctivated. Reread Delay can prevent undesired m ultiple

reads of the same label while in this mode.

Default = Level Mode.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 155 156

Sem comentários

HP Retail Jacket for ElitePad Manual do Utilizador Página 25